360 panorama pixilates Flash interactive

Using Pano2VR/Object2VR SWF files with your own Flash projects
Post Reply
JAMMINBILL
Posts: 3
Joined: Tue May 04, 2010 9:06 pm

360 panorama pixilates Flash interactive

Post by JAMMINBILL » Thu May 06, 2010 3:00 am

I was elated to finally figure out how to link to the panorama.swf from my Flash file. It loads and plays perfectly in response to a button event. However, while it is moving all the other elements in the Flash interactive become rough and pixilated-looking. That's not such a big deal, but when I click the close button to remove the panorama from the stage, the entire Flash interactive is still pixilated. I've noticed that when the panorama is stopped that the pixilation goes away, but if it's moving when the close button is clicked, then the pixilation becomes permanent. I'm assuming this is because Flash is still executing the panorama code even though it's been removed. I've had the same trouble with flv files. Although they are removed from the stage you can still here the audio playing. This is a huge problem. Any thoughts?

matts3dfloorplans
Posts: 1
Joined: Fri May 07, 2010 4:48 pm

Re: 360 panorama pixilates Flash interactive

Post by matts3dfloorplans » Fri May 07, 2010 4:52 pm

There is an export setting to turn this on and off. I think it might be the "change stage quality" setting.

JAMMINBILL
Posts: 3
Joined: Tue May 04, 2010 9:06 pm

Re: 360 panorama pixilates Flash interactive

Post by JAMMINBILL » Mon May 10, 2010 7:17 am

I cannot thank you enough. Your suggestion worked perfectly. I am elated. I wish I could paste the link here so you could see it, but it's still in preview mode and the website folks would burn my car and beat me to death if I posted it for the general public at this point. Thanks again.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests