Page 1 of 1
Can't set viewing limits
Posted: Mon Mar 04, 2024 2:53 pm
by ffurger
I was just experimenting with a pano of my living room. A simple cylindrical pano, nothing special about it.
I took a partial panorama, i.e. less than 360 degree.
I then tried to set the viewing limits left and right in the Properties panel, but the relevant numeric fields for the left and right limits are grayed out. See attachment.
Any suggestions?
Thank you very much!
Re: Can't set viewing limits
Posted: Mon Mar 04, 2024 3:15 pm
by Hopki
Hi,
This is because the left and right limits are determined by the width of the cylinder.
Under the input image properties, you can adjust the Horizontal FoV.
- Screenshot 2024-03-04 at 14.13.26.png (27.4 KiB) Viewed 1039 times
Regards,
Re: Can't set viewing limits
Posted: Mon Mar 04, 2024 3:31 pm
by ffurger
Nope, I can do that, of course, but I do I still can't set the left and right viewing limits.
Re: Can't set viewing limits
Posted: Mon Mar 04, 2024 3:32 pm
by ffurger
Oh, one more thing. Pano2VR picks a rectilinear projection, cylindrical is not available in the drop-down menu.
Re: Can't set viewing limits
Posted: Mon Mar 04, 2024 3:37 pm
by Hopki
This sounds very odd, can you send your input image to support, the link is below.
But its in the list, open a new project even without an input image.
- Screenshot 2024-03-04 at 14.35.32.png (78 KiB) Viewed 1036 times
You will see Cylinder in the list.
Regards,
Re: Can't set viewing limits
Posted: Mon Mar 04, 2024 3:40 pm
by ffurger
True, if I simply open the application and click on the drop-down menu I do see an option for cylindrical projection. I'll send you my panorama
Re: Can't set viewing limits
Posted: Mon Mar 04, 2024 3:45 pm
by ffurger
Well, my pano is 90 MB, I can't send it be email. Do you have some way for me to upload it?