Garden Gnome Software

Hi.

I would like to ask if it is possible when you are working in a project, how to show on the map only the nodes that belong to a plant, even though all the nodes of the project are already located on the map. I just want to see the nodes per floor isolated. I have assigned labels per floor and also assigned the floor levels for publication in GSV.
I want to avoid to see all the levels at the same time as the screen shot attached.
Also, GSV doesn't recognize the levels correctly when they are not overlapped so if they can't be seen by floors it's a real mess to have all the levels overlap while you are working on the project. Many hanks
Javier

Hi Javier,
Pano2VR can filter the Tour Browser and Tour Map using tags, text and distance.
The filter can be found in the tour browser.
Please see our documentation page: https://ggnome.com/doc/pano2vr/project- ... lter-tags/
Regards

Hi Hopki.

Thanks for the fast answer.
As I described, all the nodes are tagged per floor and created the GSV level floors names but even filtering by tags all the nodes are visibles on the map as as showed with the screenshot.

All my best

Hi,
Please take a look at the Pano2VR Settings page: https://ggnome.com/doc/pano2vr/getting- ... /#advanced
I am sure that "Use filter for map pins & ghost hotspots" is selected by default.
But make sure yours is selected.
As you filter the nodes in the tour browser the Tour Map will also filter.
Nodes D and E have the tag, B. As this is entered in the nodes without the filter will be filtered out from the tour browser and map.
May even be worth selecting Show Map labels as this is also good to have on.
Regards,

Aplogize me.
I don't know how I did it but now it does hide the levels. Thank you very much, Hopki !