I was just experimenting with a pano of my living room. A simple cylindrical pano, nothing special about it.
I took a partial panorama, i.e. less than 360 degree.
I then tried to set the viewing limits left and right in the Properties panel, but the relevant numeric fields for the left and right limits are grayed out. See attachment.
Any suggestions?
Thank you very much!
Can't set viewing limits
- Hopki
- Gnome
- Posts: 13196
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi,
This is because the left and right limits are determined by the width of the cylinder.
Under the input image properties, you can adjust the Horizontal FoV.
Regards,
This is because the left and right limits are determined by the width of the cylinder.
Under the input image properties, you can adjust the Horizontal FoV.
Regards,
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
- Hopki
- Gnome
- Posts: 13196
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
This sounds very odd, can you send your input image to support, the link is below.
But its in the list, open a new project even without an input image.
You will see Cylinder in the list.
Regards,
But its in the list, open a new project even without an input image.
You will see Cylinder in the list.
Regards,
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/