Hi,
I have another problem with Pano2vr. The problem is with Animation.
I do things like this:
1. Go to the Animation tab,
2. I click on the green plus,
3. Enter the name "1" or any other name,
4. I click "ok".
At this point, Pano2vr shuts down every time.
I was using the animation a few months ago and everything worked fine.
What can I do to be able to use the Animation?
Pano2vr is closing when adding a clip in an animation
- Hopki
- Gnome
- Posts: 13029
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi,
This sounds like a graphics driver issue.
Maybe you have had a Windows update that has changed the driver?
To test this, open a pano2VR project.
Right button click in the viewer and select Projections.
Now change to stereographic projection, does Pano2VR close?
If so then visit the website of your graphics card and download the latest driver for your card.
Note not Windows update does not always install the best driver.
Regards,
This sounds like a graphics driver issue.
Maybe you have had a Windows update that has changed the driver?
To test this, open a pano2VR project.
Right button click in the viewer and select Projections.
Now change to stereographic projection, does Pano2VR close?
If so then visit the website of your graphics card and download the latest driver for your card.
Note not Windows update does not always install the best driver.
Regards,
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
- Hopki
- Gnome
- Posts: 13029
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi,
This still points to derivers, does your computer have two graphics cards?
Some computers have integrated graphics such as Intel HD along with a High-Performance card.
Make sure Pano2VR uses the High-Performance card, this is normally set in the cards control panel.
Regards,
This still points to derivers, does your computer have two graphics cards?
Some computers have integrated graphics such as Intel HD along with a High-Performance card.
Make sure Pano2VR uses the High-Performance card, this is normally set in the cards control panel.
Regards,
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/