Hi _All,
I use a radar beam in a map in my tour and have two problems:
- the beam in browser is misdirected approximate 180 degree.
the modifier is adjusted with target - rotate / Source - pan north / Factor - 1 / Offset - 0
the hotspot has defined North
I've saw the posts to this point, but it don't works for me.
- the beam is only going with the spot, if i choice the spot in the map.
If i choice the next hotspot in pano, beam stays with the last spot
Does somebody has any idea?
that would be great!
Thanks so much
Stephan
pano2VR 6.0.5 radar beam alignment
- Hopki
- Gnome
- Posts: 13025
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi Stephan,
The radar will point to the North set in the pano.
Rotate the pano until you are looking north.
Use the N key to show the compass in the viewer then rotate it using the mouse the same way you did to rotate the panorama.
With the N key held down, the pano will not move but the compass will.
Once set correctly the beam will point in the correct direction.
Regards,
Hopki
The radar will point to the North set in the pano.
Rotate the pano until you are looking north.
Use the N key to show the compass in the viewer then rotate it using the mouse the same way you did to rotate the panorama.
With the N key held down, the pano will not move but the compass will.
Once set correctly the beam will point in the correct direction.
Regards,
Hopki
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/