pano2VR 6.0.5 radar beam alignment

Special forum to share and discuss skins for Pano2VR and Object2VR
Post Reply
klonk
Posts: 10
Joined: Mon Mar 21, 2016 10:09 am

Hi _All,
I use a radar beam in a map in my tour and have two problems:

- the beam in browser is misdirected approximate 180 degree.
the modifier is adjusted with target - rotate / Source - pan north / Factor - 1 / Offset - 0
the hotspot has defined North
I've saw the posts to this point, but it don't works for me.

- the beam is only going with the spot, if i choice the spot in the map.
If i choice the next hotspot in pano, beam stays with the last spot

Does somebody has any idea?
that would be great!
Thanks so much
Stephan
Screenshot 2019-07-11 13.02.01.png
Screenshot 2019-07-11 13.02.01.png (2.46 MiB) Viewed 3420 times
User avatar
Hopki
Gnome
Posts: 13005
Joined: Thu Jan 10, 2008 3:16 pm
Location: Layer de la Haye, Essex UK
Contact:

Hi Stephan,
The radar will point to the North set in the pano.
Rotate the pano until you are looking north.
Use the N key to show the compass in the viewer then rotate it using the mouse the same way you did to rotate the panorama.
With the N key held down, the pano will not move but the compass will.
Once set correctly the beam will point in the correct direction.
Regards,
Hopki
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
klonk
Posts: 10
Joined: Mon Mar 21, 2016 10:09 am

Hopki, thanks so much for your helpful hint!
I've found your tutorial for add floor plans (great tut, thank you therefore) and built new this part of project. Now it works fine.
Regards
Stephan
Post Reply