Please see attached images as they best illustrate my challenge. I have an HTML output with "Full Page" ticked, however in the case of an iPhone, the images are loading too far down the screen (most extreme), same with iPad in landscape mode. I'm loading these as an "include" in my WordPress site, however I don't believe this to be a WordPress (or WP theme issue) as the "raw" html output also suffers from the same vertical challenge:
WordPress:
http://morper.net/vintage-camera-collec ... st-camera/
Direct "raw" output:
http://cameras.morper.net.s3.amazonaws. ... index.html
As you can see in the "direct..." link above, when you vertically constrain the browser window, the images maintain center and the nav controls drop to the bottom. Is there a way to anchor to the top of the page?
Any other suggestions?
HTML "Full Page" output not scaling for mobile devices
- Hopki
- Gnome
- Posts: 13025
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi,
What is the plugin settings for width and height.
Set width to 100%.
Regards,
Hopki
What is the plugin settings for width and height.
Set width to 100%.
Regards,
Hopki
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
Hi Hopki... to be clear, are you referring to configuring the GGPKG WordPress plugin as follows (see attached)?
If so, doing so precludes my ggpkg from even loading now. Sorry if I am misunderstanding your recommendation.
If so, doing so precludes my ggpkg from even loading now. Sorry if I am misunderstanding your recommendation.
- Attachments
-
- Screen Shot 2018-02-02 at 8.13.55 AM.png (102.13 KiB) Viewed 6713 times
I can confirm that setting the width to 100% (as represented in the screenshot in this thread) does not work. Specifically, the object refuses to render. I have to explicitly input both width and height values (not percentage values) for it to render.
What's more, I also confirmed that setting the value to 100% "broke" the plugin. I had to uninstall then reinstall to regain use of the plugin. I know I recently read in another thread on this board a similar issue happen to someone else.
What's more, I also confirmed that setting the value to 100% "broke" the plugin. I had to uninstall then reinstall to regain use of the plugin. I know I recently read in another thread on this board a similar issue happen to someone else.
- Hopki
- Gnome
- Posts: 13025
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi,
You need to set a height value, normally the Theme adjusts this while the plugin adjust the width.
Regards,
Hopki
You need to set a height value, normally the Theme adjusts this while the plugin adjust the width.
Regards,
Hopki
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/