switch between 3D Stereoscopic (side by side) View and general default view

[sridharraju]

Hi Hopki,
I was following your tutorials on HMD Files and How to and ....
Was looking out for an option to switch between 3D Stereoscopic (side by side) View and general default view.
I was intending that the default view to be normal pano and on selection only the pano should go side by side/3D Stereoscopic view.
I tried the tour given by you and it was generating the Stereo side by side view without any trouble. But I wish, the default view could be a normal VR and my viewer should be able to toggle between the Stereo side by side view and a normal pano view for my purpose.
Can I request for some help ?
I'm using Pano2VR 5.0beta4 pro 64bit

Regards ...

Sridhar Raju

[Hopki]

HI Sridhar,
I will make a post and project files on how to do this.
But in short its two outputs that share the same tiles folder but then has separate HTML page and skin.
You then switch between the HTML pages with a Go To URL action.
Ill add it to the VR post.
Regards,
Hopki

[360Texas]

Today Hopki wrote: "So all you would do is have a button in the skin to Go To URL to the VR html page.
And then one back to the normal view."

Please read more about this:
viewtopic.php?f=6&t=10176&p=42894#p42894

[sridharraju]

Thanks a lot Hopki and Dave .. !!
look forward for more updates on this ...
I'm still looking at some more finer points in this issue. Even the technology is still in incubation stage on HMD, & HTML5, when I'm placing a set of buttons for stereo vr for HMD, the buttons are appearing in both the splits with individual controls, and I'm looking out for ways to put a button to navigate previous and next pano since point hotspots are not fitting in for some specific cases. I would love to have a draggable thumbnail box without a slider since it reduces the screen space and looks simple on a mobile screen.....

Thanks again ....

Sridhar Raju