Hello,
now it runs - I am happy !
BUT there was a tricky little thing:
As you can see in my above screenshot, there was a setting for the radar in the very first commandline:
on mouseclick -> set element position -> to $self ->target: radar
this line is needed to make shure that the red dot is mooved to the new pano - it marks the actual active panorama - instead of blue dot ( that is shown before).
So I had following problem:
I clicked on blue dot, the loading text and loading bar has been shown - it SEEMED to load the new panorama - also the blue dot was overmasked with the red dot, all seem correkt - BUT the panorama was still the same in the window...
This behaviour was until I did a new setup of the skin:
I deleted this first line: on mouseclick -> set element position -> to $self ->target: radar
So the first command (the first line) for a mouseclick was the "open next panorama"
I tested and it worked fine,
next i added the radar line again: -> on mouseclick -> set element position -> to $self ->target: radar
but this time this line was not the first commandline, but the last line - and after that - it works well, you can see it under the same link:
http://panobilder.de/immotour-id-aa001/ ... aa001.html
this is the flash version.
Also a html5 version is running, but I guess it´s not useable on i-phone as the floormap is too large.
But it should look good on an i-pod, so,
is there anyone here to test this with i-pod ??
i-pod panorama-tour:
http://panobilder.de/mobiletour-id-aa00 ... aa001.html
And let the community know, what is good / bad / nice / ugly / fast / slow or anything else...
Many thanks !!
PS: the html5 tour works pretty good in the Safari browers, on my WIN7 PC.