Feedback on first projects

Q&A about the latest versions
Post Reply
BWilkinson
Posts: 6
Joined: Fri Mar 01, 2013 1:56 pm

Feedback on first projects

Post by BWilkinson » Mon Mar 04, 2013 11:16 pm

Hi all,

I'm just learning at this point and looking for criticism. This is a train station here in Worcester MA. I am using gigapan head with the gigapan stitch software prior to coming into Pano2VR. 50% overlap. FOV 26.1. 50mm 1.4 on 5D Mark III. Raw to JPG without color correction. Some issues with floor pattern are noticeable.

I am not convinced I have the correct "projection?" of the stitched image when I come into pano2vr. PanoVR is recognizing these images as Cylinders. The walls look ok enough but the floor and ceiling are very distorted. Any feedback and suggestions welcome. Previews and links to hosted versions below.

mainhall.preview.jpg
Main Hall
mainhall.preview.jpg (71.58 KiB) Viewed 977 times
concorse.preview.jpg
Concourse
concorse.preview.jpg (66.33 KiB) Viewed 977 times
- Brian
Last edited by BWilkinson on Fri Mar 15, 2013 1:08 am, edited 1 time in total.

BWilkinson
Posts: 6
Joined: Fri Mar 01, 2013 1:56 pm

Re: Feedback on first projects

Post by BWilkinson » Tue Mar 05, 2013 7:11 am

Appears that I was creating Equirectangular out of Gigapan Stitch but wasn't selecting Equirectangular as an input type in pano2vr. Things are looking much better now. - Brian

smooth
Posts: 1493
Joined: Sat Sep 09, 2006 7:30 pm

Re: Feedback on first projects

Post by smooth » Tue Mar 05, 2013 8:48 am

Pano2VR will auto detect Equirectangular image on input, so long as the file is 2:1 aspect ratio (exactly twice as wide as hight in pixels)
Odd pixel either direction will cause it to fail. I.E 10000x5000 = Equirectangular 99999x49998 = Fail

Regards, Smooth 8)
www.omnipix.com.au
Image

Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests