Page 1 of 1

Cannot set Pan limits

Posted: Tue Jul 21, 2009 4:03 pm
by AlanR
Pano2VR2.2.3 Mac OSX 10.5.7

Viewing Limits question

Hi - Any ideas why I cannot set pan limits when I can set tilt limits ? The word "set" is greyed out on the left /right boxes but not in the top / bottom ones. Source image is full 360 cylindrical but I only want to make a flash movie showing 270 or so....

Help!

Many thanks to anybody who can solve my (probably obvious stupidity) problem....

Alan

Re: Cannot set Pan limits

Posted: Tue Jul 21, 2009 5:11 pm
by smooth
Alan,

If you know what the FOV you want you can enter this when selecting Input Type: Cylindrical FOV: 270
Your alternative is to set your Cylindrical panorama onto a 2:1 equirectangular canvas as I describe in this thread http://gardengnomesoftware.com/forum/vi ... 616&p=6428

Hopefully this will get you going.

Regards, Smooth 8)

Re: Cannot set Pan limits

Posted: Wed Jul 22, 2009 5:23 pm
by AlanR
"If you know what the FOV you want you can enter this when selecting Input Type: Cylindrical FOV: 270"

Thanks mate - I had just figured this out moments before reading before reading your post!

Many thanks for the advice anyhow.

Cheers,

Alan