Page 1 of 1

Hotspots disappear if not using rectilinear projection

Posted: Mon Jul 19, 2021 10:07 pm
by IAtkin
Hi all

I have been away from Pano2VR for a while and I am having a problem while finding my way around it again.

I have built a small tour with no unusual features and using the supplied simplex_v6 skin. I am on version 6.1.13 pro 64 bit on WIndows 10.

On viewing the tour, if I change the projection to something other than rectilinear the hotspots disappear. Why would this be?

The tour can be viewed at this link: https://www.birchwood360.co.uk/tours/garden2021-07/.

The issue is the same with every other skin I have except for one using chevrons (I can't remember if that is a built in skin or not)

Thanks
Ian

Re: Hotspots disappear if not using rectilinear projection

Posted: Mon Jul 19, 2021 10:44 pm
by Hopki
Hi Ian,
Hotspots can only be mapped in the Rectilinear Projection, the only exception is 3D Arrows.
There is a feature request for hotspots to be visible in the other projections.
Regards,

Re: Hotspots disappear if not using rectilinear projection

Posted: Wed Jul 21, 2021 6:13 pm
by IAtkin
Hopki wrote:
Mon Jul 19, 2021 10:44 pm
Hi Ian,
Hotspots can only be mapped in the Rectilinear Projection, the only exception is 3D Arrows.
There is a feature request for hotspots to be visible in the other projections.
Regards,
Thank you - that rather succinctly explains it! :)

PS - Apologies for the slow response, the email notification went to my spam folder and I didn't notice