How do I set a starting point for each panorama? / Error

[Patrick]

I want to give each panorama its own starting point.
So I set the desired start view and then click on set. However, this point is then adopted for all panoatamen. I do not use the function "copy for all panoramas" !!!
Where is my mistake here?

[k.ary.n]

Did you have more than one node selected in the Tour Browser?

You could also try a different method by right-clicking in the Viewer and choosing "Set Default View".

Another thought is, does this happen in every project you open? If so, it could be that you've set the default view for the Default Project Settings. If so, you can reset this by going to File > Reset Default.

[Hopki]

Hi Patrick,
Another thought, In Pano2VR pro, if you move one panorama by say 20 degrees, then all panoramas will move by 20 degrees.
To check the default view just right button click in the viewer and select Go To Default View.
This will then show the default view set for that node.
To save time you can also use this to Set the Default View.
Regards,