Garden Gnome Software

Hi.
Am putting first tours together and all going well but I am bit stumped with what I'm sure has a very simple solution.

The tours start on little planet view and fly in to equirectangular view. I want to add an image/message with play button before the fly in.

I have 2 tours one above the other on same web page and viewer misses the fly in on 2nd tour as there is no pause at start. Would also be nice to put info message at start.
I tried searching the forum but pause/play and other search terms I tried just show too much stuff.

Really loving this software and the forum/help/videos!

Many thanks for any pointers.

Dylan.

Can anyone point me in the right direction?
Am just wanting a paused info screen, before the initial fly-in and tour commences.

Cheers,
Dylan.

Hi Dylan,
There are a few ways to do this.
1) use a timer
2) use a custom fly-in made in animation
If using animation just give it 2 seconds before you start the animation fly-in.

For the timer, set it to start, then one time.
Then on Config loaded, set the view to the stereo view, then on deactivate use a move to default view action.
Regards,

Many thanks
Just seen the reply, I assumed I'd get an email if thread was updated.

Timers are something I haven't tried as yet - I'll give that a go now. Really appreciate being pointed in right direction!
Cheers,
Dylan.

Hi Machew,

I assumed I'd get an email if the thread was updated.

If you want an email when the thread is updated make sure you check 'Notify me when a reply is posted'


cheers,

Tony

Thanks Tony.
I just assumed that I'd be auto subscribed to a thread I created.
Assumption is the mother of all....

Cheers,
Dylan.

Hi martin, you are clear but

I would like to know if there is the possibility of starting the fly-in following a tap on the initial welcome photograph (splash screen)
thanks
luca

Hi luca,
I was using a timer, but the action will be the same in a splash screen, just swop out the source action from Activated to mouse click.
So...
"Then on Config loaded, set the view to the stereo view, then on mouse cLick use a move to default view action.
Regards,