Cloner position

Q&A about the latest versions
Post Reply
MPorosło
Posts: 9
Joined: Sun Mar 08, 2020 9:49 pm

Mon Mar 16, 2020 10:58 pm

I have added a "POI" cloner. The position is set as a percentage. I would like the "POI" cloner to always be below the "floor" cloner. Now, when the view window gets smaller, the "POI" cloner hides under the "floor" cloner. Is it possible to set the "POI" cloner so that it is always below the "floor" cloner (3.mp4)
Attachments
3.mp4
(956.95 KiB) Downloaded 6 times
MPorosło
Posts: 9
Joined: Sun Mar 08, 2020 9:49 pm

Mon Mar 23, 2020 2:21 pm

Hi,
I built a small project.

https://1drv.ms/u/s!At6kUfQ01h6DiB7ZG0C ... C?e=ntL2eI

Regards,
Post Reply