Page 1 of 1
BUG? Bottom LIMITS are off after 6.1.1 Update
Posted: Sat Oct 26, 2019 4:02 am
by TheRealMojoJojo
Hi,
Unless the limit settings have been intentionally changed, I think I have found a bug.
I have noticed that the bottom pan limits are off by about 35 degrees as the max is now 125 instead of the usual 90.
- limits-off.jpg (213.29 KiB) Viewed 2018 times
Thanks!
Re: BUG? Bottom LIMITS are off after 6.1.1 Update
Posted: Sat Oct 26, 2019 4:19 am
by TheRealMojoJojo
After some further tinkering, you can actually pan to the bottom 160 degrees:
- 160-pan.jpg (174.74 KiB) Viewed 2015 times
Re: BUG? Bottom LIMITS are off after 6.1.1 Update
Posted: Mon Oct 28, 2019 9:53 pm
by Hopki
Hi,
What your seeing is what you see in the viewer.
- limits-off.jpg (219.56 KiB) Viewed 1997 times
I hope this explains what is going on.
When looking down, depending on FoV you also see more or less, in this case, -125.00
Regards,
Hopki
Re: BUG? Bottom LIMITS are off after 6.1.1 Update
Posted: Wed Oct 30, 2019 3:50 am
by TheRealMojoJojo
HAHA,
Yes, but does the view also go UPSIDE DOWN?
.
- upside-dpown.jpg (552.98 KiB) Viewed 1989 times
.
Check this out
https://youtu.be/hMhC6jwkk2w
Re: BUG? Bottom LIMITS are off after 6.1.1 Update
Posted: Wed Oct 30, 2019 9:53 am
by Hopki
Hi,
It does if you change the viewing limit, screenshot from Pano2VR 6.0
- Screenshot 2019-10-30 at 08.48.43.png (28.76 KiB) Viewed 1982 times
Here I have set the bottom to -760, makes for a rollercoaster ride, if your stomach can handle it.
But as it makes quite a few people feel a bit nauseous it's limited to -90 up and down.
Cheers,
Hopki