Leveling the pano
I am a newbie struggling with leveling the pano.. I have followed this ( https://ggnome.com/doc/pano2vr/beta/prep-leveling ) step by step, I get one side level, and then turn the pano 90 degrees and it's way off again. Follow the steps again and same thing happens as soon as I turn the pano. Very frustrating. What am I missing here? Where is the auto level feature that mentioned in the documentation?
- Hopki
- Gnome
- Posts: 13005
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi,
The best way to attack this is to use both properties and viewing parameters panels.
• Add your panorama and in the viewing parameters make sure your at pan 0
• In the Properties use Roll to adjust, you're looking for anything vertical. Use the grid to help you in the viewer
• Back in viewing parameters set the pan to 90
• Back in the Properties adjust Pitch, again until vertical lines are set.
Once mastered you'll be able to open a pano, hold down the "L" key, click and drag the sides until level, then, rotate the pano about 90 degrees and repeat.
Regards,
Hopki
The best way to attack this is to use both properties and viewing parameters panels.
• Add your panorama and in the viewing parameters make sure your at pan 0
• In the Properties use Roll to adjust, you're looking for anything vertical. Use the grid to help you in the viewer
• Back in viewing parameters set the pan to 90
• Back in the Properties adjust Pitch, again until vertical lines are set.
Once mastered you'll be able to open a pano, hold down the "L" key, click and drag the sides until level, then, rotate the pano about 90 degrees and repeat.
Regards,
Hopki
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/