Erroneous missing files message at start-up
Posted: Fri Oct 05, 2018 11:24 am
Hi
I can create a new tour using Pano2VRv6.0b4, save it, close Pano2VR, re-launch Pano2VR and open the saved tour, all is well. If, however, I create nadir patches for all panos using the batch process of "Edit Master Node" then after saving and re-opening a tour I get the attached error message. The properties for the patches created remains as per the software default, namely "patches\master_$n_patch.psd" and I can confirm that the folder "patches" exists and that the files located within it are named accordingly. Indeed, after clicking on "OK" the panos and their patches all load properly.
Not really a problem but it's annoying and something somewhere is obviously not right . . .
I can create a new tour using Pano2VRv6.0b4, save it, close Pano2VR, re-launch Pano2VR and open the saved tour, all is well. If, however, I create nadir patches for all panos using the batch process of "Edit Master Node" then after saving and re-opening a tour I get the attached error message. The properties for the patches created remains as per the software default, namely "patches\master_$n_patch.psd" and I can confirm that the folder "patches" exists and that the files located within it are named accordingly. Indeed, after clicking on "OK" the panos and their patches all load properly.
Not really a problem but it's annoying and something somewhere is obviously not right . . .