Control Transition Time with Actions

[dennisvanduijn]

Hi folks,

Would it be possible to change the Transition Time from one pano to another by using an action? The following path leads to where I'd expect it to be: Action Settings > Mouse Click > Player Settings > Change Transition > Dip to Color > no transition time?

Any thoughts?

Kind regards,

Dennis van Duijn

[Hopki]

Hi,
Switch to expert mode and you will see crossdissolve/2/2
This is Cross dissolve, zoom in, and zoom in.
While in expert mode you can add time, example crossdissolve/2/2/4
This is: Cross dissolve, zoom in, and zoom in with 4 second transition time.
Regards,
Hopki

[dennisvanduijn]

Hi Hopki,

Many thanks, I did not know it was that easy! A point of interest is that I had to find out that the action to change the transition has to be put at the top of all the other actions to be sure it is performed first.

Dennis

[Hopki]

Hi,
Pano2VRs logic is actions are executed from the top down.

As a further example, Animation sequence, if you do not have auto rotate set in the project file but have an animation, when you click the button to start the animation then interrupt the sequence it stops for good.

To have it start again after a delay time then you would first add a mouse click, start auto rotate action which allows you to set the delay timer, then the next action is the mouse click, start animation.

So on click Auto Rotate is activated with all its timers then the Animation sequence is activated and used.
This is the same for logic blocks, the logic stops when the first condition is met.
Regards,
Hopki