Fly in to default view.

[flyingrobot]

I was wondering if someone could help me. I presume we are able to zoom in (move/rotate) from one location to another when transitioning from node to node. Under viewing parameters I set the fly in location (the start) using the center marker. From there I select the end point where the transition should end in the next node, using default view. I have done that for every node. When I click generate output it does the transition correctly on load. But when I select the next node it does not perform my expected behavior. The same is repeated for the other behavior.

I made a video of this. Thanks in advance.

https://youtu.be/JHDmvHz8Fa0

Leon Herbert

[Hopki]

Hi Leon,
Under transition you need to select After: Fly In.
Regards,
Hopki

[flyingrobot]

Thanks Hopki!