the Sigma 10mm 2.8 was calibrated on IKEA museum here in Sweden
Dave do you want to see the calibration images
Advice from experienced
Yes Sir the 8 mm Samyang was calibrated on IKEA factory in Poland
the Sigma 10mm 2.8 was calibrated on IKEA museum here in Sweden
Dave do you want to see the calibration images
the Sigma 10mm 2.8 was calibrated on IKEA museum here in Sweden
Dave do you want to see the calibration images
-
360Texas
- Moderator
- Posts: 3516
- Joined: Sat Sep 09, 2006 6:06 pm
- Location: Fort Worth, Texas USA
- Contact:
Thank you but not now. Your imaging results are sharp, clear, no parallax issues.
The Canon 5d does not have LCD SCREEN LIVE VIEW. Which makes it easier to view the two poles.
This is what I see when setting up a NPP calibration. Notice the black TICK mark on front pole (near lens face) is same thickness as WHITE pole 3 meters away.
I took this picture using my Samsung s7 curve Smartphone pointed into the very small 5d view finder hole.
The Canon 5d does not have LCD SCREEN LIVE VIEW. Which makes it easier to view the two poles.
This is what I see when setting up a NPP calibration. Notice the black TICK mark on front pole (near lens face) is same thickness as WHITE pole 3 meters away.
I took this picture using my Samsung s7 curve Smartphone pointed into the very small 5d view finder hole.
- center.jpg (317.39 KiB) Viewed 1101 times
-
stekly.milos
- Posts: 35
- Joined: Tue Nov 08, 2016 1:50 pm
Dear Friends!
I would like to close this case
Thank you very much for your time and support. See the link below of resolution. There is a room which looks easy but it´s really difficult to stich. But I have done it with the Nodal Ninja 4. Also the tripod is OK. See another virtual tour which is wrong. I think that the head NN3 is wrong. Now I can start to work with NN4 (stitching in PTgui is "very good", stitching from NN3 only "good" or "not too bad"). I think I have to return NN3 to my dealer.
https://goo.gl/photos/Qu3YstLEPBAJzh5D6
Thanks all to help!
Milos
I would like to close this case
Thank you very much for your time and support. See the link below of resolution. There is a room which looks easy but it´s really difficult to stich. But I have done it with the Nodal Ninja 4. Also the tripod is OK. See another virtual tour which is wrong. I think that the head NN3 is wrong. Now I can start to work with NN4 (stitching in PTgui is "very good", stitching from NN3 only "good" or "not too bad"). I think I have to return NN3 to my dealer.https://goo.gl/photos/Qu3YstLEPBAJzh5D6
Thanks all to help!
Milos