Garden Gnome Software

Hello,

I have a question about the quaility of the picture while is zoom out.

When I see the virtual tour while is zoom out it seems quite of blurry, but when i zoom in, the quality of the virtual tour is clear.

Is there any setting in order to see the virtual tour clear while zoom out without having to zoom in for better quality.

Sample (I used multi resulotun):
http://lemonimage.com/wp-content/upload ... dex_1.html

Thanks a lot,
Panayiotis

HI Panayiotis,
I have moved this topic to the Pano2VR general forum as its more of a question rather than just showing off your work.
The question you ask may be down to your display, high quality displays will need a different switch bias setting for multi resolution.
Under the Flash output and Advanced tab you will see the Switch Bias setting, the default is 0.4.
This controls at what point does the next resolution get used, switches, image pixels vs screen pixels.
The closer to 1 you get the faster it will switch, the downside is you can end up switching sooner.

In version 5 and the HTML5 output we have put in two switch bias settings, one for high DPI (HiDPI) displays, so you can have the default 0.4 and 1.0, depending on display type will depend on which switch bias it will use.

As your using Flash I would set your Flash Switch bias to say 0.8 and see if that helps, if not then use 1.0.
Regards,
Hopki

Hello Hopki,

Thanks for the answer.

It work great.

Panayiotis
www.lemonimage.com