I know that I can do a batch to add a mirror ball to equirectangular sources and than use it in a new p2vr project. But is it possible to do this simple patch on the first pano and have copied to all the others directly in the tour project?
Domenico
Theta patch nadir in batch mode
- Hopki
- Gnome
- Posts: 13026
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi Domenico,
It must be added to the master node.
To accurately patch, first patch the first pano,the patch should have the location in the file name.
If your using version 4 you will need to select this in the settings / preferences, this is found under the advanced tab.
Then remove the patch from node one and select the master node.
Then add the patch using the pan, tilt, roll and FoV in the file name.
Regards,
Hopki
It must be added to the master node.
To accurately patch, first patch the first pano,the patch should have the location in the file name.
If your using version 4 you will need to select this in the settings / preferences, this is found under the advanced tab.
Then remove the patch from node one and select the master node.
Then add the patch using the pan, tilt, roll and FoV in the file name.
Regards,
Hopki
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/