Garden Gnome Software

Yes, the Sound is working now; much better navigation as well.
Jersey is Awesome today. The weather is terrific, after a nice full day of showers yesterday.
My wife and I will be taking a break to enjoy the park this afternoon.

One more question, please. It appears that the Sound Control is not Global. If I pause it on the entry, if I change to another node in the tour, the sound starts to run again. Is there a way to render the settings Global?

Hi DrJS,
How have you set up your sound?
How have you added the sound to the project and which modes.
BTW, Jersey grate place, was there last year.
Me the wife and a Theta
Regards,
Hopki

Hi Hopkl,

Yes, Jersey is pretty GREAT! Lots of Beaches and forests to hike and relax. We enjoy our Summers here as well as Fall and Spring Seasons. I tried Florida for a few months and found it too flat and boring. The Heat was unbearable, but made the best out of the situation.

As for my project, I tried to load the Sound file into the Master Mode, but can't seem to get the Global control effect when I tried to manage the sound module. Any ideas on how to do it?

Just took a peek at your Theta link... Is that you and your Wife? You guys look so happy. And, what is that little black item on the table?

https://theta360.com/en/

@ Hopki You should try your RICOH 360 camera on a long stick

Svendus wrote:https://theta360.com/en/

@ Hopki You should try your RICOH 360 camera on a long stick

@ DrJS it is global if you watch it in Google Chrome in Firefox 39 it is not try upgrade to Firefox 40 it should work

Yes, The play function is Global; however, when I tried to STOP or Pause, it does not carry over to the next node, because the music restarts. I think this behavior might be annoying to someone at an office .
Any ideas on how to better control the STOP or Pause functions in the player controls?

THETA, I have heard about this camera and read about it from Google. It seems to pass the You Tube upload test and it is ready to go for Google.

Hi DrJS,
Start a new thread in the Pano2VR forum as we are hijacking Svendus website post.
Regards,
Hopki

Hi Svendus,
I just noticed the sound starting level does not match the volume bar.
Make sure your sound level is 0.4, thats where the bar starts in the skin.
Or change the position of the bar to match the volume level.

Note if changing the volume_meter in the skin you will need to adjust its start position and then in the + / - buttons adjust the Limits.
Regards,
Hopki

All right 0.4 Fixed should be on all panos to make it Global thank You

EDIT: one have to go to max and then down to one to get it right

Hi Svendus,
If you set the level to the sound to 0.4 then it should be good.
Regards,
Hopki