Page 1 of 1

Levels adjustment

Posted: Wed Aug 30, 2017 4:15 pm
by AHansen
I have three levels after positioning each of the three levels individually as a set . I now have to adjust them individually to line up with the elevator in each floor . Is there a way to select level two and then select all the images and move them at the same time to the right spot over level one . Then select level three and move all those images at the same time and put the elevator on top of the other elevator ?

Re: Levels adjustment

Posted: Wed Aug 30, 2017 4:49 pm
by Hopki
Hi,
Not in version 5.x.x.
This will be one of the features in version 6.0 out in a few months or so.
Regards,
Hopki