No top view?

[Cyberslam]

Hi,

Is there anyway to restrict the user from viewing the top view of virtual tours?

Thanks

[thomas]

What do you mean with "top view"? Limiting the tilt angle? If so: Yes, you can change those values in the "Viewing Parameter" box on the settings tab.

[Cyberslam]

I will check out the "viewing parameters" options.

By no top view i mean the user should only be able to view the virtual tour horizontally not the full 360 degree.

[Cyberslam]

I played around in the viewing parameters option but can't seem to find what i am looking for.

[360Texas]

Return to the Viewing parameters click check mark middle of the panel "View viewing parameters".

now you should see angle of view values on all 4 sides to the image. In particular locate the values in the top and bottom boxes. The should read 90 and -90.

+90 degrees from center 0 to image top
Consider 0 to be mid center on the horizon.
-90 from mid center 0 to the image bottom.

So you do not want see the top area.. then reduce the +90 upper viewing limit to only see up to say +70 degrees above the horizon. Same for the lower area