Page 2 of 2

Re: Multirow ObjectVR - but how?

Posted: Fri Feb 20, 2009 1:00 pm
by PhotoSpherix
I can not think of a great way but one that will get you close is to use a piece of string to stay at the same radius from the center of the rotating turntable. It is not to difficult to do in set up, but it is hard to do when you are actually shooting. The sting gets in the way.

Use a thumbtack and a 4ft piece of string. Tack the string to the center of the turntable and tie the other end to an area near the mounting screw for the camera. This way the camera stays the same distance from the object. Now carefully find a way to move the camera and tripod to different locations around that radius. by moving the tripod in and up. You will need to re aim the camera to the thumbtack each time that you move in and up. Easy without an object on the turntable, but real hard with an object.

Re: Multirow ObjectVR - but how?

Posted: Tue Feb 24, 2009 11:34 pm
by digimg02
So simple, I like it. I was hoping to not have to run around with a tape measure and a piece of paper.

Re: Multirow ObjectVR - but how?

Posted: Wed Feb 25, 2009 2:55 pm
by 360Texas
5 or 6 years ago a Canadian friend of mine used "thin transparent fishing line" as a guide wire to object model a small single engine aircraft. The transparent fishing line works well as it blends with the ground... and is easy to clone out.

Re: Multirow ObjectVR - but how?

Posted: Tue Jul 07, 2009 1:18 am
by pbeddis
Hi guys!

I thought it might be worth mentioning the equipment we use for multi-row objects... http://www.virtuall.cz/en/category/foto ... rview/arm/.

Hope it helps.

Re: Multirow ObjectVR - but how?

Posted: Mon Dec 21, 2015 3:27 pm
by dancoss
Hi does anybody have a system for aligning objects while shooting a multi state 360ยบ ( for instance three objects different material )

Thanks

Merry Xmas

Re: Multirow ObjectVR - but how?

Posted: Mon Dec 21, 2015 9:23 pm
by Hopki
Hi,
You could set up lasers or even simpler use objects mark the location before you move the object.
Regards,
Hopki

Re: Multirow ObjectVR - but how?

Posted: Mon Dec 21, 2015 11:12 pm
by Svendus
yes a cheap laser pointer on a tripod works fine