Garden Gnome Software

Hi there

I have just created an object360 and have rendered an 3d object showing only 180 degrees of itself.
When I bring this into Object 2vr I only want you to be able to pan back and forth through a 180 degrees.
At the moment it pans 360 degrees so I get a big jump at the rear of the object as it returns to the start.
How can I lock it donw to 180 degree pan only?

Any Ideas please.
Thanks
Greg

Hi Greg,
Under viewing parameters deselect Horizontal wrap.
Have a look at this document for a better understanding.
Regards,
Hopki

Again, thank you very much.

Greg