Hi,
again a little problem that drives one crazy...
I played now an hour and I KNOW that there was a solution given by Martin, but do not find it...
Problem: visiblity depending on pan, but the "gap" on the +-180° angle cannot be solved.
visible depending on pan
- soulbrother
- Posts: 547
- Joined: Tue Apr 08, 2008 7:01 pm
- Location: München
- Contact:
- Hopki
- Gnome
- Posts: 13027
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi,
This requires two entries in the condition.
As an example:
Node ID = node1 AND
Pan = > 175 AND
Pan = < 180 OR
NodeID = node1
Pan = < -175 AND
Pan = > -180
This would give you 10 degrees so + 175 and - 175
Once set you can copy this logic block and paste it to other attributes.
Note I have included Node ID, this is important if a multi-node project, if only a single node project then remove the Node ID.
Regards,
This requires two entries in the condition.
As an example:
Node ID = node1 AND
Pan = > 175 AND
Pan = < 180 OR
NodeID = node1
Pan = < -175 AND
Pan = > -180
This would give you 10 degrees so + 175 and - 175
Once set you can copy this logic block and paste it to other attributes.
Note I have included Node ID, this is important if a multi-node project, if only a single node project then remove the Node ID.
Regards,
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
- soulbrother
- Posts: 547
- Joined: Tue Apr 08, 2008 7:01 pm
- Location: München
- Contact:
Thanks a lot Hopki!