Page 1 of 1

pano2VR 6.0.5 radar beam alignment

Posted: Thu Jul 11, 2019 1:03 pm
by klonk
Hi _All,
I use a radar beam in a map in my tour and have two problems:

- the beam in browser is misdirected approximate 180 degree.
the modifier is adjusted with target - rotate / Source - pan north / Factor - 1 / Offset - 0
the hotspot has defined North
I've saw the posts to this point, but it don't works for me.

- the beam is only going with the spot, if i choice the spot in the map.
If i choice the next hotspot in pano, beam stays with the last spot

Does somebody has any idea?
that would be great!
Thanks so much
Stephan
Screenshot 2019-07-11 13.02.01.png
Screenshot 2019-07-11 13.02.01.png (2.46 MiB) Viewed 150 times

Re: pano2VR 6.0.5 radar beam alignment

Posted: Thu Jul 11, 2019 11:02 pm
by Hopki
Hi Stephan,
The radar will point to the North set in the pano.
Rotate the pano until you are looking north.
Use the N key to show the compass in the viewer then rotate it using the mouse the same way you did to rotate the panorama.
With the N key held down, the pano will not move but the compass will.
Once set correctly the beam will point in the correct direction.
Regards,
Hopki

Re: pano2VR 6.0.5 radar beam alignment

Posted: Sat Jul 13, 2019 4:59 pm
by klonk
Hopki, thanks so much for your helpful hint!
I've found your tutorial for add floor plans (great tut, thank you therefore) and built new this part of project. Now it works fine.
Regards
Stephan