Page 1 of 1

Visible Hotspot by Pan Angle

Posted: Thu May 23, 2019 8:33 pm
by Hopki
Hi,
Here is a three node project that uses an Alpha Logic block that uses Pan as the trigger to fade in the Point Hotspot when you have rotated the panorama to the desired position. Both the Hotspot Images are in a container, it is this container that has the Alpha Logic Block.

In my example, I have three nodes each expression is locked to a node.
Here you see the first node is between -22 and 22, so this is easy. I have also included a Node trigger so this will only happen in node1.

1.png
1.png (40.52 KiB) Viewed 1013 times

This next one is a little more tricky as it is showing two hotspots for node2, but the back hotspot is between -157 and 157, so you can not use an And here. This is an extream case as most hotspots will be between either positive or negative numbers, for example, 10 to 30, -10 to -30.
As I am using an Or I must also include the NodeID before each of the Or statements, so Node And Pan Or Node And Pan.

The good news is you can select the conditions and copy and paste them into another expression.

2.png
2.png (68 KiB) Viewed 1013 times

The last node, node3 just has the hotspot show to come back.

3.png
3.png (47.97 KiB) Viewed 1013 times

This is actually very logical when you think about it.
And as a helper, I have added two text boxes, one to display the pan angles and the other the current node.

I will be writing up a feature request to make this easier as we know the pan and tilt of each hotspot it is just a case of being able to set a distance from it to show.

Further reading about Logic Blocks can be found HERE.

Regards,
Hopki

Re: Visible Hotspot by Pan Angle

Posted: Fri Jun 14, 2019 5:36 pm
by IBCreative
Very clever 👏👏

Re: Visible Hotspot by Pan Angle

Posted: Mon Jun 17, 2019 7:33 pm
by xi4
I understand that node is the number of the panorama? How to set another value? If I have 200 panoramas on a tour, then by number, this is not an option at all. If you did as in the screenshot, it does not work (

Re: Visible Hotspot by Pan Angle

Posted: Fri Aug 16, 2019 9:08 am
by TheCat
Guess you've found the solution already but for others who might stumble across: Just apply a title to your nodes and use $(ut) as trigger instead.

Re: Visible Hotspot by Pan Angle

Posted: Sat Aug 24, 2019 2:21 pm
by xi4
Есть пример? Как это выглядит?

Re: Visible Hotspot by Pan Angle

Posted: Sat Aug 24, 2019 5:43 pm
by 360Texas
Google translator says:

Есть пример? Как это выглядит?

"There is an example of? How does it look?"