Node with line

Special forum to share and discuss skins for Pano2VR and Object2VR
Post Reply
SergePix
Posts: 45
Joined: Fri Feb 01, 2019 2:27 pm

Node with line

Post by SergePix » Sat Mar 09, 2019 11:33 pm

Hello
I'm doing 360 aerial photos. All my photos, are on a gps point. Is it possible to have on the 360, a line that starts from the GPS point of the ground up to the icon. Like the picture?
Attachments
node-line.jpg
node-line.jpg (26.16 KiB) Viewed 324 times
Serge
Version: 6.1.1 pro 64bit
Windows 10

mbb
Posts: 212
Joined: Mon Oct 19, 2009 11:42 pm

Re: Node with line

Post by mbb » Sun Mar 10, 2019 5:40 am

Yes, a hotspot template as viewed in the skin editor shows a "target" icon. Make your hotpot imagery align in relation to that "target". In the case of your example, the bottom of the vertical line would be aligned with the template's "target" icon.

SergePix
Posts: 45
Joined: Fri Feb 01, 2019 2:27 pm

Re: Node with line

Post by SergePix » Sun Mar 10, 2019 6:31 pm

I'm not sure if I understand your explanation, but I did it in 2 ways:
1 - In the skin editor, I drew a rectangle of a very thin length under the hotspot.
and
2 - On the pano, I have drew a polygon from the hotspot to the surface at the spot I think is closest to the GPS point.

The polygon gives me a better precision, however I do not know, since iI have the gps coordinates, if it is possible to be even more precise on the pano.

But it's a good start.

Thanks for your help!
Attachments
node-line-compare.jpg
node-line-compare.jpg (41.3 KiB) Viewed 301 times
Serge
Version: 6.1.1 pro 64bit
Windows 10

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests