Hello
I'm doing 360 aerial photos. All my photos, are on a gps point. Is it possible to have on the 360, a line that starts from the GPS point of the ground up to the icon. Like the picture?
Node with line
Yes, a hotspot template as viewed in the skin editor shows a "target" icon. Make your hotpot imagery align in relation to that "target". In the case of your example, the bottom of the vertical line would be aligned with the template's "target" icon.
I'm not sure if I understand your explanation, but I did it in 2 ways:
1 - In the skin editor, I drew a rectangle of a very thin length under the hotspot.
and
2 - On the pano, I have drew a polygon from the hotspot to the surface at the spot I think is closest to the GPS point.
The polygon gives me a better precision, however I do not know, since iI have the gps coordinates, if it is possible to be even more precise on the pano.
But it's a good start.
Thanks for your help!
1 - In the skin editor, I drew a rectangle of a very thin length under the hotspot.
and
2 - On the pano, I have drew a polygon from the hotspot to the surface at the spot I think is closest to the GPS point.
The polygon gives me a better precision, however I do not know, since iI have the gps coordinates, if it is possible to be even more precise on the pano.
But it's a good start.
Thanks for your help!
- Attachments
-
- node-line-compare.jpg (41.3 KiB) Viewed 4429 times
Serge
Version: V7.01
Windows 10
Version: V7.01
Windows 10