Page 1 of 1
Assign actions to polygon hotspot? And border width?
Posted: Mon Oct 30, 2017 8:15 pm
by Frankster69
Hi Gnomers,
A small question: how can I assign actions to a polygon hotspot? I have assigned the action to stop autorotate on mouse-over to all my clickable spots, I just can't figure out how to add that to the polygon.
And how can I make the border thicker? I want to give the background full transparency and show a border of about 3 pixels wide. Is that possible?
regards, Frank
Re: Assign actions to polygon hotspot? And border width?
Posted: Mon Oct 30, 2017 8:57 pm
by Hopki
Hi Frank,
You can't change the border width at the moment, this is a feature request so will happen at some point.
You assign actions to a polygon hotspots using the Hotspot Proxy ID.
When you add a Poly Hotspot change the ID to say pop01.
Then back in the skin editor add a rectangle and in its properties panel enter pop01 when it says Hotspot Proxy ID.
Any actions assigned to the rectangle will then be actioned when the poly is clicked.
You can then of course hide the rectangle in the skin.
Regards,
Hopki
Re: Assign actions to polygon hotspot? And border width?
Posted: Tue Oct 31, 2017 1:46 pm
by Frankster69
Hi Martin,
Ok, thanks, that's not difficult, I'll implement it today to try
regards, Frank
Re: Assign actions to polygon hotspot? And border width?
Posted: Sun Feb 25, 2018 8:06 pm
by benmckaydesigns
Hi, this doesn't seem to work for me. It would be a great feature to include on future versions to add the "actions" option directly to the polygon drop-down menu on the tour builder(pano/url/action), easier than going back and forward between the builder and the skin editor creating boxes, assigning IDs... not very practical or intuitive.
Thanks
Re: Assign actions to polygon hotspot? And border width?
Posted: Mon Feb 26, 2018 10:04 pm
by Hopki
Hi,
Polygons were only ever meant for changing nodes, so therefore their interaction with the skin is limited.
easier than going back and forward between the builder and the skin editor
You just add the poly, give it a unique ID then go to the skin editor to build what it should interact with.
this doesn't seem to work for me
What bits not working, can you post your project?
Regards,
Hopki
Re: Assign actions to polygon hotspot? And border width?
Posted: Thu Jun 08, 2023 10:42 pm
by mmpano
I'm looking for a way to increase the border width of a polygon hotspot when the mouse enters the polygon. Is there a way to do this or just increase the size of the hotspot border? Thanks!
Re: Assign actions to polygon hotspot? And border width?
Posted: Fri Jun 09, 2023 4:16 pm
by Hopki
Hi,
Border width can not be changed.
You can however using Hotspot Proxy ID change the colour of a polygon on mouse enter, and change it back on mouse leave.
See the attached project.
Regards,
Re: Assign actions to polygon hotspot? And border width?
Posted: Fri Jun 09, 2023 4:32 pm
by mmpano
That's too bad. Is there a plan to add this feature?